EZC-2 Assembly Instructions:

  1- EZ Carrier comes pre-assembled in a factory sealed box.

2- Place Platform into Hitch Assembly.

3- Align Platform 3 Hole to Hitch 3 Hole

4- Place 4" bolt with Nyloch Nut into Hole 3 and Tighten

5- Place Hitch & Platform assembly into receiver hitch

6- Align Hole in your Hitch / Platform with hole in Vehicle receiver Hitch.

7- Place Safety Hitch Pin with ring to side.

8- Place 4" Hitch Pin with ring Handle into Hole to lock platform into place.

9- Attach Ramp Bracket to the right rear exterior of Platform.

10- Lift ramp with handle and secure it in an upright position by releasing the hinge Pin.

11- Attach reflectors to carrier platform side rail.

Hold onto Ramp and Pull Hinge pin towards vehicle.

Guide to ground with both hands.

Load scooter or Powerchair up the ramp and onto platform.

Secure as desired or per manufacturer specifications utilizing the optional straps

Raise Platform ramp and secure it with hinge pin into top hole of ramp bracket.

                          Ready to Travel

Folding Instructions of the EZC-2 Platform:

To fold the EZ Carrier towards vehicle ( no scooter or powerchair on platform).

Pull ramp hinge out and fold loading ramp onto platform.

Secure with the hinge Pin.

Remove Hitch Pin Handle from the hole.

Carefully Lift platform towards front of vehicle..

Once stable in upright position, place hitch pin completely through hole 1 and reattach safety ring to hitch pin. Carrier is secure and ready for travel.

Description:

The E-Z Carrier Fold up version, allows for your total mobility transporting at the most

economical value possible. This wheelchair or scooter Carrier is designed for those who

 wish to take their mobility scooter or power wheelchair on trips but do not have the room

 to put the scooter in their car, van or SUV.

This scooter carrier′s 36 inch ramp allows for your total mobility transporting at the most

 economical value possible.

The simple yet functional design requires no batteries, motors or actuators.

Simply unfold the ramp, load the scooter or wheelchair, fold up the ramp, strap and go!

When not in use the Carrier folds up, as shown

Specifications:

Model Number:	EZC-2
Platform Size:	Width 28" x  Length 50" Foldable
Loading Ramp Size	Width 27.5" x Length 42 " Single Fold
Weight Capacity:	400 lbs.
Finish:	Black Powder Coated
Total Weight	66 lbs
Hitch Requirement:	Class II ( 1 1/4" X 1 1/4") or Class III (2"X 2")
Platform Material:	Steel
Warranty:	10 Year Limited Factory Warranty

                              Click Below for EZ-Carrier Accessories